Although this week has seen a lot of experimentation I have actually made some progress. With the siding point laid the sleepers were glued in place for both that siding and the other one. Rails were then soldered in place on the top siding. After a bit of fiddling I've found that a small coping saw cut in the rail only causes a small bump from the stock. As a result the rails have been cut into at the top to represent the 30ft rails being used, matching the sleeper spacings. This looks great at the minute but I wonder if I'm being too pedantic and it'll disappear when it's ballasted/plastered in. That said the rail breaks are great for insulation gaps. Later I'll gently rub off the copper to insulate the two rails and add mock fishplates to the joints. A great advantage of laying onto glued sleepers is that I don't nee to use fishplates to join the rails. Each sector is powered by wires soldered to the bottom of the rail and run down through the baseboard.
The experimentation has revolved around couplings and uncoupling. To lay the track I needed to finalise the uncoupling magnets. So to test and work out how high to place the Greenwich permanent magnets and SEEP electromagnets I had to make up some couplings. For those to work I had to devise my way of mounting the couplings at the right height to the stock. I copied someone's idea of pinning the couplings to a balsa block at the right height and, after a load of work, decided this was weak and awkward. The best idea I had at the end was to place a blob of Blu Tac against the coupling height gauge, stick the coupling gauge in it and then offer up the wagon; much better!
So now I have some wagons with couplings, knowledge on how to place the magnets and therefore was able to place the magnets and lay the track. All in all a lot of work to lay a 14" siding but work that needed to be done! The baseboard frame is also making good progress which is fortunate a I don't want to lay much more track until the board and frame are as one.
3 comments:
Just discovered this blog, interesting idea, will be watching to see how things progress. I'll add a link to http://narrowgauge.wikispaces.com if you don't object?
Tom, quite happy to have a link added. Hopefully if I can keep the momentum going people can read this with as much interest as yours and some of the other layouts that I've found online.
Thanks, i have to admit i've been rather lazy with my site and posted more on RMweb than there recently. Thinking about doing away with it actually until the next layout. It all comes up in google on RMweb anyway!
If you're a 009 soc member ask for a link to be added to their website, brought in a few interested people for me!
Post a Comment